Special pressure sintering furnace for cemented carbide

---

The special pressure sintering furnace for cemented carbide is mainly used in the fields of cemented carbide, high specific gravity alloy, silicon nitride, alumina, boron nitride, carbon carbon composites and other high-tech materials.

Each equipment of pressure sintering furnace needs to have a speed-up process when it is running. Only through the normal speed-up can it reach the set speed without harming the equipment. The same is true of the start-up process of the special pressure sintering furnace for cemented carbide. When it is just started, the speed of the special pressure sintering furnace for cemented carbide needs a buffer time, that is, the process of increasing the speed of the equipment, and then it can enter the normal operation period.

The following and SIMUWU vacuum furnace manufacturer analysis of cemented carbide special pressure sintering furnace start slow problem how to solve.

First of all, before starting the special pressure sintering furnace for cemented carbide, we need to verify the loading amount of raw materials in the machine. If the loading amount of raw materials exceeds the kinetic energy range of the sintering furnace, the starting speed will be too slow, which means that the machine is in the loading state as soon as it is started. In addition, the running in condition of the rotating shaft of the special pressure sintering furnace for cemented carbide should be checked before starting up to see the smooth condition of the rotating shaft of the special pressure sintering furnace for cemented carbide. In fact, if the rotating shaft of the special pressure sintering furnace for cemented carbide is started up and operated without smooth treatment, it is easy to cause the special pressure sintering furnace for cemented carbide to start slowly. If it is serious, it may be difficult The problem of sudden shutdown of special pressure sintering furnace for cemented carbide is formed.

Maintenance of special pressure sintering furnace for cemented carbide

1. The mesh belt is a thimble mesh belt. Please use sandpaper to polish the thimble end to prevent scratches on the battery. If it is a diagonal mesh belt, bake it at low speed at the speed of 100 to eliminate organic matter.

2. If the lamp is infected with organic matter, please be careful to use alcohol cotton or non-woven cloth to scrub.

3. Cleaning operation inside the chamber (attention should be paid to whether the air holes are blocked).

4. For the cleaning operation of organic exhaust and hot exhaust (including factory affairs and equipment, as well as the lampblack box of the equipment), please use alcohol to clean the organic matter on the equipment.