How to prolong the service life of vacuum sintering furnace

Vacuum sintering furnace is widely used in the vacuum sintering treatment of ceramics, silicon carbide, cemented carbide materials, photoelectric plating mold materials and graphite purification. In the use of vacuum sintering furnace, maintenance is required, and only good maintenance can be used for a longer time.
If the mesh belt is a thimble mesh belt, please polish the thimble end with sandpaper, etc. to prevent scratches on the battery. If it is a diagonal mesh belt, bake it at a low speed at a speed of 100 to remove organic matters.

If the lamp is infected with organic matter, please be careful to use alcohol cotton or non-woven cloth to scrub. Clean the interior of the chamber (pay attention to whether the air holes are blocked). Please use alcohol to clean the organic and hot exhaust (including the factory and equipment, as well as the fume box of the equipment).

When the sealing structure, vacuum system and other parts on the furnace are disassembled, they shall be cleaned with alcohol or gasoline and dried, then coated with vacuum grease and assembled.

In case of inaccurate limit, control failure and clamping of all transmission parts, stop immediately and do not operate forcibly to avoid damage to the parts.
After the vacuum sintering furnace is shut down, the vacuum degree in the furnace must be kept below 66.5lpa.

Vacuum pumps, valves, measuring instruments, thermal instruments, electrical components and other accessories must be used, repaired and maintained in accordance with the technical instructions of the product.

The maintenance operation shall be carried out without power supply. If the maintenance is carried out under electrified condition, it must be carried out by professional maintenance personnel, while ensuring the absolute safety of personnel and equipment. The mechanical transmission parts of aluminum plate spot welding machine of vacuum sintering furnace shall be regularly oiled or changed for maintenance.