burn off oven manufacturer

burn off oven can efficiently and safely wash chemicals attached to coating nozzles and other metal parts. Use of polymer is higher than 300 degrees was isolated from the air can be cracking, above 400 degrees in a small amount of air can completely oxidation characteristics, first with polymer sewage workpiece heated to 400 degrees (proposed) according to the technical requirement, make the workpiece on the number of polymer melt flowing to a collection container at the bottom of the furnace, and then the temperature rises to 400 degrees, and ventilation with a small amount of fresh air, make the rest of the polymer oxidative, generates carbon dioxide, after water spray with pump, water ring type with water from outside.

Working principle of burn off oven
burn off oven has two relatively independent heating system as well as temperature and smoke control system. In the first heating system, the furnace chamber is heated to a certain temperature range by excluding the effect drawing, and the temperature inside the furnace is automatically controlled by the control system, so that the coating on the workpiece is gradually decomposed into gas. The control system always guarantees the decomposition rate and the concentration of decomposition products and strictly controls them within a certain range. When the decomposed substance passes through the second heating system and is transformed into CO2 and water vapor after high temperature treatment, it is discharged through the chimney. What is left in the furnace is the workpiece and the inorganic substance that is not affected. These inorganic substances have become powder, and most of them have fallen on the bottom and bottom plate of the furnace.

Use for burn off oven
1. Remove the continuously thickened coating on the spraying fixture and fixture without changing the mechanical properties of the fixture.
2. Completely and completely peel off the unqualified paint or powder coating on the surface of steel parts and aluminum parts without any damage to the workpiece.
3. Remove the filter screen and fan impeller adhesive paint layer of spray curtain cabinet.
4. Clean and remove wire, cable, transformer, motor, winding and adhesive organic matters on the printing roller.
5. Clean and remove grease, grease and other organic matters on engine, crankshaft, box, piston ring and other parts.

burn off oven features
1. the treatment of burn off oven beyond the traditional burning, chemical method caused by high cost, toxicity, to the operator, the workpiece deformation is large, causing environmental pollution and other problems. The use of burn off oven not only low cost, low labor intensity, small deformation, and safe, non-toxic, pollution-free.
2. Simple operation, just press the start button to complete the whole process, no special training is required for the operator.
3. reduce energy consumption (50% of similar products), no special requirements on the number, shape and size of the workpiece, can ensure that the workpiece deformation.
4. Sealing design ensures the sealing performance.
5. with aluminum silicate fiber as the main heat insulation material, to ensure good heat insulation performance and service life.
6. the combustion engine and the main control elements are all imported parts.
7. equipped with programmable controller (PLC) and solid state relay.
8. Advanced tobacco control methods.
9. It has a five-level safety protection system.